Wheel chock cart
A mobile safety solution for trucks, semi-trailers and trailers during parking, loading and unloading. Two approved AL-KO UK53-K2 wheel chocks secure the wheel from the front and rear, while their mechanical mounting allows them to adjust automatically to the tire.
A chock that moves away instead of fighting the operator
Secure
Lower the cart. The chocks automatically position themselves against the tire and secure the wheel from both the front and rear.
Pull the handle
When the cart is pulled away, the chock tilts and drops instead of bracing against the tire. There is no need to release the chock manually or jerk the entire cart.
Easy removal
The chock comes out from under the wheel without being forcibly pulled out. This reduces the risk of damage to the chock, its mounting and the cart structure.
Only this much extends beyond the vehicle
Once the cart is positioned, approximately 25 cm of the structure is under the vehicle and approximately 25 cm extends beyond its outline. The cart therefore does not unnecessarily occupy space between adjacent loading bays.
Approved AL-KO chocks
Two black AL-KO UK53-K2 plastic chocks. They are much lighter than steel chocks, so when the cart is moved over paving blocks or uneven surfaces they bounce less and put less strain on the structure.
No bending down
The operator handles the safety device using the handle. There is no need to manually place and remove each chock from under the wheel.
High visibility
Reflective tape is fitted on both sides of the cart and on the chocks. This makes the safety device easier to see, including from the driver's position and in the mirror.
The cart was designed primarily to secure semi-trailers at loading docks.
When a semi-trailer is standing without a tractor unit, forklift movement inside the trailer – including entering, exiting and braking – may cause the trailer to move relative to the loading dock. The chocks restrict wheel movement in both directions.
The cart can also be used while parked and in other situations where mechanical protection against vehicle movement is required.
The cart mechanism operates entirely mechanically. No electronics, drives or actuators are used.
Steel brackets secured with wing screws are mounted on the steel crossbar. The chocks are attached to the brackets using a washer and retaining pin, without modifying the chock itself.
Because the chocks can move and tilt, they can adjust to the wheel and release from under the tire when the cart is removed, without forceful pulling.
If an individual component becomes worn or damaged, there is no need to replace the entire device.
The following can be replaced separately:
- individual chock,
- chock with bracket,
- crossbar,
- wheels,
- cart without the crossbar.
| Intended use | trucks, semi-trailers and trailers |
| Main application | securing during parking, loading and unloading |
| Construction | steel |
| Surface protection | galvanized |
| Overall height | 103 cm |
| Lower beam width | 121 cm |
| Handle width | 45,5 cm |
| Weight | ok. 15 kg |
| Number of chocks | 2 |
| Chocks | AL-KO UK53-K2, black |
| Approved chocks | yes |
| Chock spacing range | up to 111 cm |
| Adjustment method | mechanical |
| Wheel securing | front and rear |
| Chock mechanism crossbar | steel, 40 mm |
| Transport wheels | solid, steel and rubber |
| Wheel diameter | 160 mm |
| Extension beyond vehicle outline | approx. 25 cm |
| Section under the vehicle | approx. 25 cm |
| Reflective elements | on both sides of the cart and on the chocks |
The steel cart structure is manufactured by TIRLock in Poland.
For larger deployments, versions can be tailored to the requirements of a specific logistics center or fleet, including custom colors, logos, markings, numbering and dedicated solutions.
